MicroAir Easy Start 364 Soft Starter

(No reviews yet) Write a Review
SKU:
ASY-364-X20-IP
Shipping:
Free Shipping
On Sale
Now: $269.99
Was: $299.99

Description

Micro-Air EasyStart™ - The most advanced & effective soft starter for all A/C applications
EasyStart™ is a one-of-a-kind, custom-developed soft starter for single-phase motors. It employs a 4-part start ramp sequence that is self-optimizing, resulting in the lowest possible start-up current. EasyStart can deliver 65-75% start current reduction as compared to a compressor's LRA (locked-rotor amperage). EasyStart is the perfect solution that allows an air conditioner or refrigeration compressor to operate on a generator, inverter, or limited utility power when it would otherwise not have functioned. It can also be applied to air compressor and fluid pump motors.

  • Easy Start your A/C without buying a second or bigger generator or inverter
  • Run 2 air conditioners on a 30-Amp cord. (Note: Each A/C requires an EasyStart unit)
  • Sleep, with less noise, and cool all through the night
  • Run your A/C with more appliances at the same time
  • Add an A/C unit at low cost by putting an inexpensive EasyStart on each. Avoids expensive rewiring of the entire RV to upgrade to 50-amp.
  • Convenient installation kit for wiring an RV Rooftop A/C unit is available. (sold separately)
  • The standard version can support both 115-230VAC/50-60Hz motors, and the RV version supports only 115V/50-60Hz motors.
  • Has numerous specialized fault checks not found in any other soft starter to provide further protection for your compressor.
  • The EasyStart 364 is capable of supporting up to a 36000 BTU (3 ton) compressor. It includes a fully-weatherproof (IP65), flameproof, plastic enclosure with an integrated mounting flange and a 40" (1m) wire harness.
  • Specialized models exist for various applications.
Specifications/Note
IMPORTANT INSTALLATION NOTE FOR CRUISAIR® MARINE CUSTOMERS ONLY:
  • When installing EasyStart into 220-240V SMX A-288/282/281 control applications that use the triac to switch power to the compressor, it is necessary to replace the triac with a relay. If the triac is not replaced, the EasyStart and any pump relay triggers may suffer damage and ultimately fail. Please note that this is not required for 115V SMX applications, and the triac is still safe to use.
View AllClose

0 Reviews

View AllClose